Fish - Mh Mq Sensor Flying

delay(100);

void loop() for (int i=0; i<numSensors; i++) current[i] = readSensor(i); delta[i] = (current[i] - baseline[i]) / baseline[i]; // relative change if (delta[i] > THRESHOLD && delta[i] < 0.8) // sharp rise // Flying fish detected near sensor i recordPeak(i, millis()); mh mq sensor flying fish

The flying fish passed closest to S1 at t≈120 ms. 7. Troubleshooting & False Positives | Symptom | Likely cause | Fix | |---------|--------------|-----| | Constant high readings | Sensor aging / contamination | Bake at 100°C for 1 hour (outside) | | No response to moving source | Load resistor too high | Reduce RL to 4.7 kΩ | | Slow recovery after peak | Enclosed space, no air flow | Add a small fan for ventilation | | False positives (no gas) | Temperature surge | Apply digital low‑pass filter (moving average n=5) | 8. Useful Code Snippet (Arduino) int mqPins[] = A0, A1, A2; float baseline[3]; void setup() Serial.begin(9600); for (int i=0; i<3; i++) baseline[i] = analogRead(mqPins[i]); delay(100); delay(100); void loop() for (int i=0; i&lt;numSensors; i++)